Where to buy iron on transfers
Step 1: You will need
- a t-shirt
- a transfer
- an iron
- a hard surface to iron on
- some scissors
- some brown paper
- an image to use
- some Transfer paper
- a computer, with image software
- a printer
Step 2: What is a transfer?
A transfer is an image that you can apply to material by ironing it on.
Iron-on transfers enable you to copy an image from a piece of paper onto a fabric.
By using transfers you are able to create designs that are suited to your own individual tastes.
Step 3: Get the transfer
You can buy a transfer or you can make your own from an image of your choice. You can scan an image into your computer or find one on the internet. You will need a basic image software package in order to manipulate and print the image.
Step 4: Printing a transfer
Avoid wasting any transfer paper by making a test print on plain paper first.
Use the computer software to reverse the image, so it comes out the right way on your T shirt.
Make sure that you print the transfer on the correct side of the page. This
should be clearly marked.
The transfer paper will specify which type of printer to use, but usually a laser printer is not suitable.
Step 5: Prepare the transfer
Trim the transfer around the image so it's easier to see where you are placing it on the material.
Step 6: Find a hard surface
A surface which is heat resistant and large enough to support all of the transfer is best. A wooden chopping board, or work top should be ideal.
Step 7: Set up the transfer
Put the material in place on the hard surface.
Position the transfer on the material, exactly where you want it to be in the end.
To stop the transfer being printed onto both sides of the T shirt, place brown paper in between the layers.
Step 8: Iron it on
Turn on your iron and let it heat up. The transfer, or transfer paper should give instructions as to how hot it should be. Most transfers will need a very hot iron, and a lot of pressure. However if it's too hot, you can melt the transfer and ruin the image. Also read the instructions provided about how long to keep the iron on the image.
Step 9: Remove the backingSource: m.videojug.com