Credit portal





what are terminal servers

Terminal Server tricks: Restrict “\\tsclient” drive redirection to certain directories

One particularly handy feature of recent Terminal Server (MSTSC) clients is the capability to redirect drives to the remote TS / RDP server for use in the RDP session. This is the mechanism by which you can go to \\tsclient\<driveletter> and access your data over the RDP session, without having to try and map a drive back the computer hosting the session via SMB or the like.

Although this capability is convenient, in its present form it is limited to just mapping entire drive letters; there does not appear to be a way to limit the scope of the filesystem that is redirected to a remote system to anything less than an entire drive letter. This is unfortunate, as especially with RDP-TLS, drive mapping over RDP presents a simple, secure, and attractive file copy mechanism for computers that that you want can RDP into.

The unfortunate part is more that if you don’t trust the computer that you are remoting into completely, then it’s rather dangerous to give it unrestricted access (within the confines of the user account mstsc.exe is executing as) to local drives; there’s a lot of damage that a malicious RDP server could do with that kind of access. Even if you’re a limited user, the RDP server could still steal and/or trash all your personal documents (which are again usually the most valuable data on a computer anyway).

There is, however, a little trick that you can use to try to limit the scope of RDP drive mappings. Recall that mstsc redirects drives based on drive letters; this would at first glance seem to prevent one from using any finer granularity of access than entire volumes with respect to

which portions of the filesystem are made available to the RDP server. This is not actually the case if one is a bit clever, however, because RDP can also remote drive letters that correspond to mapped network drives. and not just local volumes that have a drive letter associated with them.

With this trick, one can, say, map a drive letter to localhost at a directory under a particular drive, to be the “root directory” that is presented to the remote RDP server. From there, it’s possible to just redirect the mapped drive letter over RDP and restrict what portions of the local filesystem are accessible to the RDP server.

Note that until Vista, plain users cannot arbitrarily map to \\localhost\c$ (or other built-in shares). As a result, if you’re in the pre-Vista boat (on the client side), an administrator will need to create the share for you (since you are running as a limited user, right?) so that you can map a drive letter to it.

Edit: Hyperion points out that you can use the “subst” command to achieve the same effect as mapping a drive letter to localhost. This is actually better than what I had been doing with drive mappings, as in downlevel (pre-Vista) scenarios, you don’t have the extra headache of having to get an administrator to share out a directory for you to be able to map it as a plain user.

This entry was posted on Tuesday, October 16th, 2007 at 7:00 am and is filed under Windows. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response. or trackback from your own site.

10 Responses to “Terminal Server tricks: Restrict “\\tsclient” drive redirection to certain directories”

Category: Forex

Similar articles: