Credit portal




What is loop statement

what is loop statement

A for loop has the for keyword, followed by parentheses containing three optional expressions separated by semicolons, followed by a body which executes in each iteration of the loop.

The goal of the for loop in your example is to set the value of count. which will be compared to zahl in the if statement that follows. This is achieved in the semicolon-delimited expressions, so the loop body doesn't need to do anything.

Since the loop doesn't need to do anything, it uses the empty statement as its body.

If the ; at the end were omitted and no other changes were made, then the if statement after the for loop would itself become the body of the for loop. (That is not intended and would break the program, as you have observed.)

However, making one's loop body consist of a single ; on the same line is not the only way to write an empty loop body, nor is it probably the most sensible way to do so. It works perfectly well,

but the problem is that other readers - and perhaps the same programmer, returning to the project later - may wonder if it was actually an error. After all, one types semicolons at the ends of lines quite often when coding in a C-style language, so it's easy to type an extra one where it doesn't belong.

The other problem is that, in code where a one-line loop with ; as its body is the chosen style, it is difficult to recognize when someone actually has made the mistake of putting a ; when one doesn't belong.

Therefore, these alternatives may be preferable:

  • putting the ;. indented, on the next line -- as sh1 suggests
  • writing the loop body as an empty block, < >. rather than an empty statement
  • making the loop body a continue; statement, which simply causes the loop to move on to its next iteration (which is the same as what happens when the loop body is empty) -- also as sh1 suggests

Category: Forex

Similar articles: