When are the clocks going forward
How They Work
Some manufacturers refer to their radio controlled clocks as "atomic clocks", which isn’t really true. An atomic clock has an atomic oscillator inside (such as a cesium or rubidium oscillator). A radio controlled clock has a radio inside, which receives a signal that comes from a place where an atomic clock is located.
In the United States, the signals received by radio controlled clocks originate from NIST Radio Station WWVB. which is located near Fort Collins, Colorado. WWVB broadcasts on a frequency of 60 kHz. Your radio controlled clock actually has a miniature radio receiver inside, which is permanently tuned to receive the 60 kHz signal.
The 60 kHz signal is located in a part of the radio spectrum called LF, which stands for low frequency. This is an appropriate name, because the FM radio and TV broadcasts that we are accustomed to listening to use frequencies thousands of times higher. The lowest frequency received by any of the other radios in your house is probably 530 kHz, the bottom of the AM broadcast band. Even that frequency is nearly 10 times higher than the WWVB signal.
At 60 kHz, there isn’t enough room on the signal (bandwidth) to carry a voice or any type of audio information. Instead, all that is sent is a code, which consists of
a series of binary digits, or bits, which have only two possible values (0 or 1). These bits are generated at WWVB by raising and lowering the power of the signal. They are sent at a very slow rate of 1 bit per second, and it takes a full minute to send a complete time code, or a message that tells the clock the current date and time. When you turn a radio controlled clock on, it will probably miss the first time code, so it usually takes more than one minute to set itself (sometimes 5 minutes or longer) depending on the signal quality and the receiver design.
Once your radio controlled clock has decoded the signal from WWVB, it will synchronize its own clock to the message received by radio. Before it does so, it applies a time zone correction, based on the time zone setting that you supplied. The time broadcast by WWVB is Coordinated Universal Time (UTC), or the time kept at the Prime Meridian that passes through Greenwich, England. While a few users like their clocks to display UTC (ham radio operators, for example), most prefer to display local time. This means that the time in your area is corrected by the number of hours shown in the table.
Difference from UTC During Standard TimeSource: www.nist.gov