Credit portal




Tips on how to hang drywall

Other People Are Reading


Drywall should go up in straight rows horizontally, with no four-way intersections between pieces. The edges of the drywall should always land in the middle of wall studs. Don't build off the floor, as it may not be level. Instead, draw a level line across the wall, 4 feet down from the ceiling (the width of a drywall sheet), and hang your first piece with the long edge on top of the line, so the other side abuts the ceiling, with the short edge against the vertical corner. The 8-foot length of the drywall should put the end at the center of a stud (since studs are supposed to be set every 16 inches); if not, cut the piece to size by scoring it with a razor knife and snapping it.


Attach the drywall to the wall by sinking drywall screws every 6 inches or so along all the studs. (If you're hanging it over existing plaster, find and mark the studs with an electronic stud finder.) Set the screw heads just below the surface of the drywall, so you can run your hand over the surface and not feel them. Hang the top row of drywall first, then the bottom row, making sure the ends of the sheets on the top and bottom are on different studs. Don't worry if there is an inch or two of undrywalled space at the bottom, as the floor trim will cover it.


The seams between the pieces of drywall are plastered with joint compound to give the appearance of one smooth wall. The trick to getting it smooth is to use three layers of compound in increasingly wider and thinner applications. Start by putting mesh drywall tape over all the seams. Spread a narrow strip of compound over the seams. Put dabs of it over the screw holes as well. Let it dry, then sand it all smooth with drywall screening paper. Lay a second coat of compound, wider and thinner than the first. Sand again, then lay another wider, thinner coat. The

final coat should just skim the surface and be about a foot wide. Sand it very lightly, and the wall is ready for priming.


Please enable JavaScript to view the comments powered by Disqus.

More Like This

How to: Hang Sheetrock

How to Fix Humps in the Walls From Drywall Joints After Painting

How to Make Your Own Drywall Lift

You May Also Like

Get tips on hanging drywall in this free DIY garage remodel video.

Discover how to hang drywall over the plumbing of a new bathroom. Learn how to add a new bathroom to a home.

A new bathroom means new drywall. Learn how to add a new bathroom to a home, including tips on hanging drywall in.

Apply drywall tape along with joint compound to the seams between pieces of drywall material on wall and ceiling projects. Drywall tape.

Hanging a picture on drywall involves much more than just choosing a spot and then driving a nail through the material. Hanging.

Hanging the drywall on the walls will seem like a breeze once you've done the ceilings. Follow these directions to get it.

Learn tips and advice on how to hang a picture using drywall anchors in this free how-to DIY video.

The studs in your wall must be flush to hang drywall evenly. Uneven studs will result in uneven walls. You can fix.

The best way to hang a heavy item on the wall is to find a wooden stud and insert a screw into.

If cutting drywall is impractical for a wiring project, builders can run wires outside the wall's cavity using a method called surface.

When building or remodeling your home, there are several areas where you can do the work yourself to save huge costs in.

Hanging drywall on a ceiling is usually a two-man job, but it can be done with one person by using a lift.


Read Article

Category: Taxes

Similar articles: